Ceramic Oxygen Diffusers
1 x DAD6 diffuser will support 5 tonnes of salmon in a sea cage during sea-lice treatment with water temperatures below 15 deg C. At higher water temperature the biomass of fish that can be supported will be reduced. By way of example, at 24 deg C then one diffuser will support approximately 2 tonnes of biomass.
When made into a frame of 4 x DAD 6 diffusers, the frame will support up to 20 tonnes of salmon. Oxygen transfer is almost 100% efficient with the Dryden Aqua diffusers. A leading commercial fish farm treated 1000 tonnes of salmon supported by Dryden Aqua ceramic flat plate diffusers during sea-lice treatment and only 30 cylinders of oxygen were used by the farm. This was 1/2 the amount used by their previous flat plate diffuser. The diffusers were supplied in 2008, they are all still working which demonstrates the strength of our product.
Dryden Aqua ceramic diffuser are designed to operate at 2.5 bar, however we pressure test them at up to 20 bar, indeed they will occasionally survive 50 bar of pressure. Every other manufacturers diffuser that we have tested normally blows at under 5 bar.
Our diffusers are manufactured from a solid cast aluminum base which has been protected against corrosion.The ceramic plate is epoxy bonded into the cast, and prevented from experiencing any torsion moments, this can only be achieved by using a solid metal frame. Indeed if you place our diffuser on a concrete floor and hit it full force with a sledge hammer, there is a good chance that it will survive. However strength is nothing unless you have a high transfer coefficient, and this respect our diffusers excel. The oxygen diffusion cloud comes out of our diffusers looks like milk.
Fish TransportationThe Dryden Aqua DAD6 is the standard diffuser used by most of the fish transportation industry to provide oxygen.
There are three key points:
- The diffuser is very efficient so you don`t need to carry more oxygen
- The Dryden Aqua diffuser is very strong and does not easily break
- Health and safety, if you manage to over pressurize a DAD diffuser with transient pulse or inline pressure over 20 bar, the ceramic will not fly off like a missile. It will simply crack to release the pressure and all the ceramic will be held in place.
1 x DAD diffuser is require in tanks from 1 to 2 cubm, but often 2 diffusers are used. The tank does not need 2 diffusers but this is a legacy from other ceramic diffuser that have a tendency to break. 2 diffuser are required for tanks at 4 cubm volume. Each diffuser will pass up to 6 liters/min, but they can be valved back to under 1 liter /minute. The amount of oxygen actually required needs to be regulated by oxygen monitors.
The diffusers can be used as individual units or we can manifold them on to a stainless steel frame.
- Model DAD600
- Plate dimensions 400mm x 90mm
- Overall dimensions 430mm x 100mm x 20mm
- Maximum oxygen flow rate 6 litres per minute
- Operating pressure approx between 2 – 2.5bar ( 32 to 40 psi)
- connection size 1/4″ bsp female threaded, supplied with 1/4″ or 3/8″hose tail, Compression fitting can also be fitted, sizes available at 6/4mm and 8/6mm hose fittings